change commuinty name snmp via zpl commande

Posted on

Problem :

I want to change the community name snmp for zebra printer via zpl commands the community name snmp is public in default, i tried with ^NN command , but nothing change, this is an example :

^XA

^NN,,,loreal,loreal,loreal

^XZ

I wrote this command in file test.zpl, and I send it to the printer via FTP

Any idea ??!

NOTE : ^NN – Set SNMP

Use this command to set the Simple Network Management Protocol (SNMP) parameters.

Format: ^NNa,b,c,d,e,f

Parameters Details

a = system name Same as printer name.

b = system contact Any contact information as desired (such as a name or phrase)

c = system location The printer’s model information.

d = get community name,  Default: public

e = set community name Values: Up to 19 alphanumeric characters, Default: public

f = trap community name Values: Up to 20 alphanumeric characters, Default: public

Solution :

Hi all I found the solution for this issue :

first I create file with ZPL II commands test.zpl inside the file I wrote this command :

^XA 
^NN,,,test,test,test
^XZ

seconde I contact with printer and send this file to the printer via FTP with command line :

c:> put c:test.zpl

third I restart the printer with sending ~JR command, and I walk the MIB tree.

snmpwalk -v1 -c TEST "address IP" enterprises.10642.20.10.10.5

Leave a Reply

Your email address will not be published.